Sophisticated Design of LoviSet® PX Makes Installation Easier
15 October 2006 12:19
The single-component mould for the new LoviSet PX low-voltage joints reduces the number of installation steps to a minimum. The joint only has to be installed around the connection in order to be ready for further processing.
In larger versions, the joint halves can be separated, so that installation is also easy in confined areas. The integral cable supports absorb any loads imposed on the seal, and thus prevent leaks. The joint is hermetically sealed on all sides by the built-in seal, and can even be filled when it is tilted.
Polypropylene Co-Polymer Mould
The mould manufactured from polypropylene co-polymer also retains its impact-resistant properties at low temperatures. The joint is supplied as standard with Protolin® 4010 casting resin, however other resins are available upon request. The LoviSet PX has been designed in accordance with the new low-voltage standard EN 50393.
For more information on this company:
Lovink Enertech - Power Cable Joints, Terminations And Accessories
Copyright 2008SPG Media Limited a subsidiary of SPG Media Group PLC
